Below is one of my Vaqueros. It has a match grade barrel that I turned from Shilen blank and  Taylor Throated with a 11 degree forcing cone. This barrel happens to be 5-7/8 inches. I bobbed off the base pin so it will drop out without removing the ejector housing This also allows the ejector to travel a bit deeper to punch out those stubborn cases. It also has a Power Custom free spin pawl and my custom over travel stop.

 

I also put a 1/8 in. wide front blade on it and put serrations on the face of the blade to cut down glare. I also  widened the rear notch and ball milled out the groove in the top strap. This makes target acquisition a bit faster.